The Hong Kong University of Science and Technology · FACULTY OF ELECTRICAL ENGINEERING

ELEC1010 Chap.2 Sound, Period and Harmonic Structure

- one subject, every graph, every model, every mark
6 Chapters3-page Bible
Our own words - no uploaded lecturer files
Updated for this semester
Chapter 2 of 10 · ELEC1010

Sound, Period and Harmonic Structure

Pitch comes from repetition

A sound waveform records changing acoustic pressure. For a sustained periodic tone, select two equivalent phase points and measure the time between them. That interval is the period T. Its reciprocal is the fundamental frequency f, measured in hertz when T is measured in seconds.

Converting milliseconds before taking the reciprocal avoids the most common factor-of-one-thousand error.

Pitch is associated with repetition rate, while amplitude is associated with the strength of the pressure variation and tends to affect loudness. These are independent visual features.

A waveform can be made taller without moving its repeats closer together, or compressed horizontally without changing its peak height. In a comparison, describe horizontal spacing and vertical scale separately before deciding which tone is higher or louder.

A pure sinusoid isolates the relation because its waveform has one frequency. Realistic periodic sounds usually contain several sinusoidal components.

Harmonics occur at whole-number multiples of a fundamental, and their different amplitudes change waveform shape and tone colour. The harmonic with the largest amplitude is not automatically the fundamental. Height gives component strength; horizontal line position gives frequency.

The missing-fundamental case makes that distinction decisive.

Lines at 450, 750 and 1,050 hertz are the third, fifth and seventh multiples of 150 hertz, so the combined waveform repeats at 150 hertz even though no line is drawn there. Find the greatest common frequency step rather than choosing the lowest displayed component. Test a candidate by dividing every line frequency by it and requiring whole-number results.

Time-domain and frequency-domain evidence should agree.

A 150 hertz fundamental corresponds to a period of one divided by 150 second, approximately 6.67 milliseconds. Counting repeats in a longer window provides another estimate and reduces graph-reading error. If a proposed fundamental does not predict the observed repeat interval, revisit the selected phase points or the common-divisor calculation.

Revision should alternate both directions.

Convert periods to frequencies, infer periods from spectra, and compare harmonic sets with different amplitudes. Always finish with a sentence explaining the perceptual conclusion and its evidence. The method is stronger than memorising that a particular curve sounds high, because it works even when the fundamental is absent, the tallest harmonic changes, or units switch between seconds and milliseconds.

In this chapter

What this chapter covers

  • 01

    Acoustic pressure variation

  • 02

    Period and frequency

  • 03

    Pitch versus amplitude

  • 04

    Sinusoidal parameters

  • 05

    Harmonic multiples

  • 06

    Missing fundamentals

Worked example · free

Recover a missing fundamental

Q [8 marks]. A spectrum has lines at 450, 750 and 1,050 Hz. Find the fundamental and period. The marks shown are an AskSia study allocation, not the University's published marking scheme.
Frequency is the reciprocal of period.Frequency is the reciprocal of period. The red trace completes twice as many cycles in the same interval, so its period halves and its frequency doubles.Same time window, different repetition rateslonger T, lower fshorter T, higher ftime
Frequency is the reciprocal of period. The red trace completes twice as many cycles in the same interval, so its period halves and its frequency doubles.
  • 3Find the greatest common frequency divisor.
  • 3Take the reciprocal.
  • 2Verify each harmonic multiple.
The greatest common divisor is 150 Hz because the lines are the third, fifth and seventh harmonics. The period is 1/150 second, equal to 6.67 ms.
Sia tip — Ignore spectral heights while finding the common frequency step.
Glossary

Key terms

Period
The time interval occupied by one complete repetition.
Fundamental Frequency
The repetition rate and greatest common step of a harmonic set.
Pitch
The perceptual quality that generally rises with fundamental frequency.
Harmonic
A sinusoidal component at a whole-number multiple of the fundamental.
Missing Fundamental
A perceived fundamental absent as an explicit spectral line.
FAQ

Sound, Period and Harmonic Structure FAQ

Is the tallest spectral line always the pitch?

No. Line height shows component amplitude, while pitch follows the fundamental frequency. A taller harmonic can dominate the spectrum without changing the greatest common frequency step.

How do I convert milliseconds to frequency?

Convert milliseconds to seconds by dividing by one thousand, then take the reciprocal. Keep the time unit beside the period so a factor-of-one-thousand error becomes visible.

Can the fundamental be absent from the spectrum?

Yes. Harmonic components can share a greatest common frequency step even when no line appears at that frequency. The combined waveform still repeats at the corresponding period.

How can a proposed fundamental be checked?

Divide every spectral frequency by the proposal and require whole-number results, then take its reciprocal and compare that period with the waveform repetition. Agreement across both representations supports the choice.

Study strategy

Exam move

Practise both directions. Convert periods in seconds and milliseconds to frequencies, then find fundamentals from sets of spectral lines. For every answer, write one sentence distinguishing pitch from loudness and line location from line height. Include examples whose fundamental is absent so the lowest-line shortcut cannot survive. Run a three-evidence pitch audit whenever more than one representation is available.

The reciprocal of the candidate fundamental must match the waveform repeat interval; every spectral line must be an integer multiple of it; and the pitch comparison must follow repetition rate rather than amplitude. A candidate that passes only one view is not established. Selecting the lowest visible line may fail the whole-number test, while selecting the tallest line may describe timbre instead of pitch.

Write the checks beside the data until a missing fundamental becomes an expected structural result rather than a special case.

Working through Sound, Period and Harmonic Structure in ELEC1010? Sia is AskSia’s AI Electrical Engineering tutor — ask any ELEC1010 Sound, Period and Harmonic Structure question and get a clear, step-by-step explanation grounded in how ELEC1010 is taught and assessed. Read this chapter free, then take your hardest questions to Sia.

A+Everything unlocked
Unlocks this Bible + all 13 of your subjects at The Hong Kong University of Science and Technology, plus 1,000+ more Bibles across the AskSia library.
Sia - your ELEC1010 tutor, unlimited, worked the way the exam marks it
The full 3-page Bible + practice bank with worked solutions
Chrome extension - sync your LMS so Sia knows your deadlines
Bilingual EN / Chinese on every Bible and every Sia answer
$0.99 Trial
30-day money-back · cancel in one tap · how it works