Johns Hopkins University · FACULTY OF BIOLOGY

AS.410.696 Chap.4 Equilibrium Binding and Competition

- one subject, every graph, every model, every mark
6 Chapters3-page Bible
Our own words - no uploaded lecturer files
Updated for this semester
Chapter 4 of 8 · AS.410.696

Equilibrium Binding and Competition

Separate affinity from capacity

A saturation experiment estimates specific binding by subtracting matched nonspecific signal from total signal. In a simple one-site model, Kd marks the free-ligand concentration associated with half occupancy, while Bmax describes binding capacity.

The two parameters answer different questions and should not be interchanged.

Keep competition conditional

A competition IC50 depends on labelled-ligand concentration and affinity. The Cheng-Prusoff relation can convert that midpoint to Ki when its assumptions apply.

Fluorescence polarization offers a homogeneous competition format by translating tracer rotation into signal, but optical interference and tracer behaviour still require controls.

Construct specific binding point by point

Total and nonspecific wells must share ligand concentration, matrix, timing and detection settings.

Excess cold ligand occupies the target and leaves signal that remains through other interactions. Subtracting one constant background from a concentration-dependent nonspecific curve can distort both the plateau and midpoint. Inspect each component before fitting the difference.

Use curve geometry as a check

The specific-binding asymptote estimates capacity in the preparation.

Half that height corresponds to Kd on the concentration axis for the simple model. If the sampled range never approaches a plateau, capacity and affinity can trade off during fitting and become weakly identified.

Residual patterns or systematic curvature may indicate multiple sites, depletion or another inadequate assumption.

Correct competition only when justified

The Cheng-Prusoff denominator represents the burden created by labelled ligand in a competitive system. Its concentration and Kd must use the same units, and the inhibitor must compete within the assumed model.

A calculated Ki is not a generic correction for every decreasing curve. State equilibrium, site and depletion conditions with the result.

Connect polarization to molecular motion

A bound tracer rotates more slowly and retains more polarization during its excited-state lifetime than the free tracer. Competition releases it and usually lowers the signal.

Target and tracer concentrations determine the usable window, while fluorescent compounds and tracer binding can imitate displacement. Confirm important hits with a measurement that does not depend on the same optical behaviour.

In this chapter

What this chapter covers

  • 01

    Equilibrium Occupancy

  • 02

    Specific Binding

  • 03

    Dissociation Constant

  • 04

    Binding Capacity

  • 05

    Cheng-Prusoff Relation

  • 06

    Fluorescence Polarization

Worked example · free

Correct a competition midpoint

Q [6 marks]. AskSia-authored practice. Labelled ligand is 100 nM with Kd 50 nM, and inhibitor IC50 is 360 nM. Estimate Ki. The weighting is a study aid, not an official marking scheme.
Binding decomposition.Binding decomposition. The green specific-binding curve is the vertical difference between blue total binding and orange nonspecific binding at each ligand concentration. totalnonspecificspecific LigandBound signal
Binding decomposition. The green specific-binding curve is the vertical difference between blue total binding and orange nonspecific binding at each ligand concentration.
  • 2Calculate one plus labelled ligand divided by Kd.
  • 2Divide IC50 by the correction factor.
  • 2Interpret Ki within the competition model.
The correction factor is 3, so Ki equals 360 divided by 3, or 120 nM. The estimate is conditional on the competitive equilibrium model and the stated ligand conditions.
Sia tip — Keep ligand concentration and Kd in the same units.
Glossary

Key terms

Dissociation Constant
Dissociation Constant is the concentration linked to half occupancy in a simple binding model. It describes affinity under that model and must not be substituted for binding capacity or functional activity.
Binding Capacity
Binding Capacity is the fitted plateau representing available binding sites in the measured preparation under the assay conditions.
Specific Binding
Specific Binding is obtained by subtracting matched nonspecific signal from total binding.
FAQ

Equilibrium Binding and Competition FAQ

How are total and specific binding related?

Total binding contains saturable target binding plus nonspecific signal. Excess unlabelled ligand is used to estimate nonspecific binding under matched conditions. Subtract that value at each ligand concentration to obtain specific binding before fitting a saturation model.

Why can IC50 change between assays?

IC50 is a response midpoint under particular ligand, substrate, target and detection conditions. In competition, more labelled ligand can raise the inhibitor concentration required for half displacement. Compare matched experiments or use a justified mechanistic correction before interpreting affinity.

What does fluorescence polarization report?

Fluorescence polarization reports rotational mobility during the fluorescence lifetime. A small free tracer rotates quickly and depolarises emission, while a tracer bound to a larger complex rotates more slowly. Displacement usually lowers polarization, subject to tracer and optical controls.

Study strategy

Exam move

Draw total, nonspecific and specific binding on the same axes and explain each subtraction. Rehearse Kd, Bmax, IC50 and Ki as distinct parameter statements. For polarization, trace free tracer, bound tracer and displaced tracer while preserving the expected signal direction.

Construct a small table of matched total and cold-ligand counts, calculate specific binding point by point and check that the resulting curve can plausibly approach a plateau. Mark half the plateau and project to the concentration axis before fitting anything. Next, change labelled-ligand concentration in a competition scenario and predict the direction of IC50 movement before applying the Cheng-Prusoff relation.

Keep all concentrations in one unit and state the competition assumptions beside the answer. For fluorescence polarization, calculate one anisotropy value from parallel and perpendicular channels, then explain why the factor of two belongs in the denominator. End with one sentence each for what binding supports, what it cannot establish about function and which orthogonal assay would answer that missing question.

Working through Equilibrium Binding and Competition in AS.410.696? Sia is AskSia’s AI Biology tutor — ask any AS.410.696 Equilibrium Binding and Competition question and get a clear, step-by-step explanation grounded in how AS.410.696 is taught and assessed. Read this chapter free, then take your hardest questions to Sia.

A+Everything unlocked
Unlocks this Bible + all 8 of your subjects at Johns Hopkins University, plus 1,000+ more Bibles across the AskSia library.
Sia - your AS410696 tutor, unlimited, worked the way the exam marks it
The full 3-page Bible + practice bank with worked solutions
Chrome extension - sync your LMS so Sia knows your deadlines
Bilingual EN / Chinese on every Bible and every Sia answer
$0.99 Trial
30-day money-back · cancel in one tap · how it works