The University of Hong Kong · FACULTY OF PHYSICS

PHYS2261 Chap.8 Phase Equilibrium and Transitions

- one subject, every graph, every model, every mark
6 Chapters3-page Bible
Our own words - no uploaded lecturer files
Updated for this semester
Chapter 8 of 10 · PHYS2261

Phase Equilibrium and Transitions

Chemical potential chooses the phase

Open systems add μdN to the fundamental relation, and phases coexist at fixed temperature and pressure when their chemical potentials are equal. Away from coexistence, matter transfers toward the lower chemical potential.

Differentiating the equality along the boundary yields the Clapeyron relation linking slope, latent heat and volume change.

Direction before magnitude

Pressure favours the smaller-volume phase. The sign of a phase-boundary slope should therefore be interpreted physically after calculation rather than left as an unexplained ratio.

In this chapter

What this chapter covers

  • 01

    Chemical potential

  • 02

    Open systems

  • 03

    Phase coexistence

  • 04

    Gibbs-Duhem relation

  • 05

    Clapeyron slope

  • 06

    Latent heat

Worked example · free

Calculate a coexistence slope

Q [8 marks]. The mark allocation belongs to this authored practice task, not an official university scheme. At 300 K, L=6.0 kJ/mol and Δv=2.0×10⁻⁶ m³/mol. Find dp/dT.
The coexistence curve separates the stable regions.The coexistence curve separates the stable regions. Along the curve the two chemical potentials match; on either side the lower-potential phase is selected.Coexistence lies on equality of chemical potentialphase α stablephase β stableμ_α = μ_βtemperature Tpressure p
The coexistence curve separates the stable regions. Along the curve the two chemical potentials match; on either side the lower-potential phase is selected.
  • 2Write the Clapeyron relation.
  • 3Convert units and substitute.
  • 3Interpret the sign.
dp/dT=L/(TΔv)=1.0×10⁷ Pa/K, positive because L and Δv are positive.
Sia tip — Use the same phase order in both Δs and Δv.
Glossary

Key terms

Chemical Potential
The potential change associated with adding particles under fixed natural variables.
Phase Coexistence
A condition where phases have equal chemical potential at common temperature and pressure.
Latent Heat
Heat absorbed or released per amount during a phase transition at fixed temperature.
Clapeyron Relation
The phase-boundary slope expressed as entropy change divided by volume change.
FAQ

Phase Equilibrium and Transitions FAQ

What condition makes two phases coexist?

At a common temperature and pressure, their chemical potentials must be equal. If one were higher, transferring matter into the lower-potential phase would reduce total Gibbs energy, so coexistence could not persist.

Why can pressure lower the melting point of water-like substances?

When the solid occupies more volume than the liquid, pressure favours the smaller-volume liquid. The Clapeyron slope for melting can then be negative, so increasing pressure reduces the coexistence temperature.

How should I check a Clapeyron calculation?

Use consistent phase ordering for entropy and volume changes, verify pressure-per-temperature units, and state which phase has the larger volume. Then check whether the slope agrees with the tendency of pressure to favour smaller volume.

How do I connect chemical potential, phase diagrams and transition slopes?

At fixed temperature and pressure, the stable phase has the lower chemical potential; coexistence occurs where the chemical potentials of the phases are equal. Differentiate that equality along the boundary using dμ=-s dT+v dp, keep the same phase order in both differences and replace the entropy change by latent heat divided by temperature.

The resulting Clapeyron slope is local unless latent heat and volume change are justified as constant over a range. Check its units and predict its sign before inserting numbers: pressure favours the smaller-volume phase. Distinguish the equilibrium curve from an observed superheated or supercooled onset, because nucleation barriers delay conversion without moving the chemical-potential equality.

Use the phase rule to count how many intensive coordinates can vary with the stated number of components and phases. At a triple point three phases share the common chemical potential at one temperature and pressure; they do not occupy a two-dimensional coexistence region for a pure substance.

Study strategy

Exam move

Draw a phase boundary and label which phase has lower chemical potential on each side. Derive the Clapeyron relation from equal chemical potentials, then practise one positive-slope and one negative-slope interpretation. Always define the direction of the phase change before using latent heat and volume differences.

Begin with the open-system fundamental relation and identify chemical potential as the coefficient of particle addition under the stated natural constraints. Explain why matter transfers toward the phase with lower chemical potential at fixed temperature and pressure. Sketch two chemical-potential branches crossing and connect the crossing to phase coexistence.

On a p-T diagram, mark the stable region for each phase and draw an arrow that crosses the boundary. State what changes discontinuously and what remains common. Re-derive the Clapeyron relation from dμ=-s dT+v dp for both phases. Keep the phase order consistent in Δs and Δv, replace Δs by L/T, and check pressure-per-temperature units.

Work one transition with a positive volume change and one water-like case with a negative melting volume change. Interpret each slope using the rule that pressure favours the smaller-volume phase. Add a local-slope warning: if latent heat and volume change are treated as constants, the numerical result describes the boundary near the chosen state, not necessarily across a wide range.

Practise a sealed-container problem where heating changes the amounts of liquid and vapour while total volume is fixed. List particle conservation, phase equilibrium and the equation of state before solving. Include one question on metastability and distinguish a delayed observed transition from the equilibrium coexistence curve. Supercooling does not move the equality of chemical potentials; it reflects a nucleation barrier.

Review the Gibbs-Duhem relation as a restriction among intensive variables in a mixture rather than another potential definition. Finish with a sign audit that names the initial phase, final phase, latent-heat sign and volume-change sign. If reversing the phase direction flips only one of the two differences, the notation is inconsistent.

The final answer should always say which phase pressure or temperature favours, not merely report a calculated slope.

Working through Phase Equilibrium and Transitions in PHYS2261? Sia is AskSia’s AI Physics tutor — ask any PHYS2261 Phase Equilibrium and Transitions question and get a clear, step-by-step explanation grounded in how PHYS2261 is taught and assessed. Read this chapter free, then take your hardest questions to Sia.

A+Everything unlocked
Unlocks this Bible + all 52 of your subjects at The University of Hong Kong, plus 1,000+ more Bibles across the AskSia library.
Sia - your PHYS2261 tutor, unlimited, worked the way the exam marks it
The full 3-page Bible + practice bank with worked solutions
Chrome extension - sync your LMS so Sia knows your deadlines
Bilingual EN / Chinese on every Bible and every Sia answer
$0.99 Trial
30-day money-back · cancel in one tap · how it works