ELEC6103 Chap.9 Rain Fade, Uplink and Downlink Design
Rain Fade, Uplink and Downlink Design
One broadcast system, designed from both ends
This chapter ties the earlier link budget chapters together through a single design: a direct-broadcast television satellite in geostationary orbit, small home dishes on the ground and one professional uplink station feeding it.
Every line of that design reuses a formula you have already met, so the chapter works as a rehearsal for a long, multi-part design question.
Why a storm costs more than its attenuation
Rain hurts a downlink in two separate ways. Drops in the path absorb some carrier power, and because any absorber also emits thermal noise, the antenna that used to look at cold space now looks through a warm layer.
The system noise temperature climbs, so the noise power rises at the same moment the carrier falls. In the tutorial design the carrier drops 2.0 dB and the noise climbs 2.8 dB, so the C/N loses 4.8 dB, finishing at 11.6 dB against a 10.0 dB requirement.
The lecture presents rain margin as curves that depend on site and target availability rather than as a formula, so state the attenuation you assume.
Designing the uplink backwards
The uplink is sized from the ratio it has to deliver.
The satellite receiver stares at the warm Earth, so its noise temperature is high, and the design asks for an uplink C/N well above the downlink one so the uplink hardly affects the total. Solving the budget for transmit power gives about 95 W from a 6 m dish.
The transponder then has to raise the weak received carrier to the downlink output level, a total of 123.2 dB, split across several stages so no single amplifier exceeds the 60 dB oscillation guideline.
Checking the whole chain
Uplink and downlink ratios combine through reciprocals of linear values, never by adding decibels.
With a generous uplink the overall C/N sits just under the downlink figure, exactly the outcome a broadcast design aims for: margin is cheap at one large station and expensive across millions of small dishes. The higher frequency band goes to the uplink because the ground end can afford the power.
Finally, two-way links can reclaim idle clear-sky margin with adaptive coding and modulation, stepping down to a more robust MODCOD when rain arrives; a broadcast link has to carry its margin permanently.
What this chapter covers
- 01
Absorption and sky noise as the two penalties of rain
- 02
Margin over the receiver threshold in clear air and in rain
- 03
Five recurring errors in finished link budgets
- 04
Effect of the 3 dB and 2 dB beam contours
- 05
Solving an uplink budget for transmit power
- 06
Splitting transponder gain under the 60 dB stage rule
- 07
Why the uplink gets the higher frequency band
- 08
Overall C/N for a downlink-limited broadcast system
- 09
Adaptive coding and modulation as a use for idle margin
Worked example · free
Rain fade on a home downlink with a 9.5 dB threshold
- 2Noise power in clear air: N = -228.6 + 10 log(140) + 10 log(24 x 106) = -228.6 + 21.5 + 73.8 = -133.3 dBW, so C/N = -117.5 - (-133.3) = 15.8 dB.
- 2Noise rise in rain: 10 log(245/140) = 2.4 dB. Combined with the 2.5 dB of path attenuation, the C/N falls by 2.5 + 2.4 = 4.9 dB.
- 2C/N in rain = 15.8 - 4.9 = 10.9 dB. Margins over the 9.5 dB threshold: 15.8 - 9.5 = 6.3 dB in clear air and 10.9 - 9.5 = 1.4 dB in rain.
- 2Counting attenuation alone gives 15.8 - 2.5 = 13.3 dB in rain, an overstatement of 2.4 dB, exactly the sky-noise term.
Key terms
- Rain Attenuation
- The loss of carrier power, in decibels, as raindrops in the propagation path absorb part of the signal; on the downlink it lowers C by that amount directly.
- Sky Noise Rise
- The increase in receiver noise when rain replaces cold space in the antenna view; it equals 10 log of the rainy system temperature divided by the clear-sky one.
- Rain Margin
- Extra C/N designed into a link over clear sky so that it still meets its threshold in rain for the required fraction of time, chosen by site and availability target.
- Transponder Gain
- The end-to-end amplification a bent-pipe transponder applies, found as output power in dBW minus input power in dBW, here 123.2 dB split across stages.
- Adaptive Coding and Modulation
- A DVB-S2 feature for two-way links in which the modem changes MODCOD as conditions vary, raising throughput in clear sky and keeping the link alive in rain.
Rain Fade, Uplink and Downlink Design FAQ
Why does rain reduce C/N by more than the rain attenuation figure?
Absorbing material also radiates thermal energy. When a storm sits in the beam, the dish no longer looks at cold sky but at a warm, lossy layer, so the receiving system temperature increases. That adds a second penalty on the noise side, computed as 10 log of the temperature ratio, on top of the carrier loss. In the tutorial design that second term, 2.8 dB, is bigger than the 2 dB attenuation itself.
How large should the rain margin be?
It depends on where the earth station is and what fraction of the year the link must work. The lecture shows the margin as families of curves for Ku and Ka band that climb steeply as the availability target rises, rather than giving one equation. In an answer, quote the attenuation and temperature you are assuming, then show the margin left over the receiver threshold in both clear air and rain.
Why is the uplink placed in the higher frequency band?
Path loss grows with frequency, so the higher band is the harder one to close. The ground station can install a large dish and a high-power amplifier at modest cost, whereas every watt on the satellite is expensive in mass and solar power. Handing the tougher path to the end with power to spare explains the 17 and 12 GHz split in the broadcast tutorial, and the familiar 6 and 4 GHz pairing in C band.
Why can't a transponder use a single amplifier for all of its gain?
Very high gain at one frequency invites oscillation, because a tiny fraction of the output leaking back to the input is enough to make the stage unstable. The course applies a guideline of roughly 60 dB per stage, so a 123.2 dB requirement is divided between input and output amplifiers at different frequencies, an intermediate-frequency amplifier, and a ground-commanded attenuator that trims the total.
Is rain margin wasted when the sky is clear?
On a fixed broadcast link the spare decibels sit unused most of the year, because the satellite cannot tailor its signal to each of millions of receivers. Two-way links under DVB-S2 avoid that loss with adaptive coding and modulation: in good weather the modem selects a more efficient MODCOD and carries more data, and when a storm lowers the ratio it falls back to a sturdier one at reduced throughput.
Exam move
Rebuild the broadcast design on one sheet in the order the tutorial uses: downlink power and gain, path loss, noise, clear-air C/N, then the rain case with both penalties written as separate lines. Next, solve the uplink budget for transmit power and draw the transponder gain chain from input to output level, checking that no stage passes 60 dB.
Finally combine the two directions with reciprocals and comment on which link dominates. Once that sheet is clean, change one input at a time, such as a larger rain temperature or a dish on the 2 dB contour, and predict the direction of every result before recalculating. Keep the five-error checklist beside you and tick it off on each attempt.
Working through Rain Fade, Uplink and Downlink Design in ELEC6103? Sia is AskSia’s AI Electrical Engineering tutor — ask any ELEC6103 Rain Fade, Uplink and Downlink Design question and get a clear, step-by-step explanation grounded in how ELEC6103 is taught and assessed. Read this chapter free, then take your hardest questions to Sia.